There is metal where needed, like around the glass and Z axis. The hood feels a bit like Tupperware, but it still does a good job shielding the print area from UV light. The machine is very light and could be improved with rubber feet to prevent it from sliding around the counter. The Anycubic Photon Mono 2 has a black base that is largely plastic and a blue plastic hood. Loosen the four adjustment screws on the sides of the build plate. To level the machine, remove the vat and then place the piece of paper provided by Anycubic on the LCD screen. Leveling the build plate is fairly straightforward and only takes a piece of paper and an Allen wrench. Like all 3D printers, the Anycubic Photon Mono 2 requires calibration before its first print. Calibrating the Build Plate on the Anycubic Photon Mono 2 Screw in the vat and build plate and you’re ready for calibration. You only need to remove the LED screen protector used for shipping and apply the fresh one provided. Always keep your resin tightly sealed and safely stored out of reach of pets and children. After printing, make sure to wipe down your printer and bottles to remove smudges of uncured resin. Spilled or dripped resin should be immediately cleaned with 99% isopropyl alcohol. Make sure the room you use your resin printer in is well-ventilated to avoid inhaling fumes. Use gloves and safety glasses when pouring resin and handling uncured prints. Uncured resin is dangerous, and the solvents used to clean your prints can be irritating to the skin. The Anycubic Photon Mono 2 requires the same safety precautions as other resin printers.

Beginners tom vanderbilt review